AIREPLEAT M13

MERV 13 (F7) High Capacity Pleated Panel Filter

Airepure® Australia has selected Kimberly-Clark INTREPID® 513H Pleat Filtration Media of which is designed to provide sustained efficiency with a low pressure drop. All INTREPID Filtration Media is 100% synthetic, so it will not absorb moisture or support microbial growth. It has a lower initial pressure drop than cotton-polyester and self supporting pleat media which leads to energy savings during use.

AirePleat M13 high capacity filters can easily upgrade existing flat panel, V-Form, MERV 8 or 11 filters currently being used with little or in some circumstances less in static pressure. AirePleat M13 high capacity filters are available in actual 44mm and 100mm depths, rated to MERV 13 per ASHRAE 52.2-99. AirePleat M13 high capacity filters are suitable for variable air volume systems. Operating face velocity ranges are from 0 to 2.54 m/sec face velocity and can be used in most heating, air conditioning, or ventilating systems.

AirePleat M13 Installation

AirePleat M13 high capacity disposable pleated filters are suitable as a primary filter to meet AS 1668.2 and can be installed in universal holding frames, side access applications and similar existing hardware. They may be used as pre-filters to extend the life of AirePak, PurePak, PureCell and AireFlow-V filters in these framing systems. AirePleat M13 high capacity “elements” and “rolls” are also offered. These are pleated sections of AirePleat M13 media in selected widths with the metal backing for use in a re-useable metal frame (service pleat).

AirePleat M13 Features

• 100% Continuous hydrophobic polyolefin fibres coupled with proprietary electrostatic treating technology
• Continuous fibres to prevent fibre shredding
• Media maximising V-Pleat design
• Expanded metal grid prevents media flutter while in operation
• Diagonal and horizontal support members provide frame strength
• Moisture resistant beverage board
• MERV 13 Rating as per ASHRAE 52.2 (F7 Rating per EN779)
• AirePleat M13 is available in all the standard sizes and are available in non standard cut-down versions

Camfil AP THIRTEEN

Camfil AP THIRTEEN advantages include:

• Pleated panel filter for meeting LEED requirements
• Available in 2″ and 4″ depths
• Lowest cost of ownership for a MERV 13 filter in a pleated panel design
• Water resistant cardboard frame

The information provided on this web page is accurate at the time of printing to the best of Airepure Australia’ knowledge, however, it should not be relied upon. Circumstances differ with every installation and location therefore suitability of all Airepure products should be confirmed with a qualified Airepure Technical Representative. ©Airepure Australia 2020