Airepure® Australia has selected Kimberly-Clark INTREPID® 411H Pleat Filtration Media of which is designed to provide sustained efficiency with a low pressure drop. All INTREPID Filtration Media is 100% synthetic, so it will not absorb moisture or support microbial growth. It has a lower initial pressure drop than cotton-polyester and self supporting pleat media which leads to energy savings during use. AirePleat M11 high capacity filters can easily upgrade existing flat panel, V-Form or MERV 8 filters currently being used with little or in some circumstances less in static pressure. AirePleat M11 high capacity filters are available in nominal 25mm, 50mm and 100mm depths. All AirePleat M11 high capacity 25mm and 50mm deep filters are rated to MERV 11 per ASHRAE 52.2-99.
AirePleat M11 high capacity filters are suitable for variable air volume systems. Operating face velocity ranges are from 0 to 2.54 m/sec face velocity and can be used in most heating, air conditioning, or ventilating systems.
AirePleat M11 high capacity disposable pleated filters are suitable as a primary filter to meet AS 1668.2 and can be installed in universal holding frames, side access applications and similar existing hardware. They may be used as pre-filters to extend the life of AirePak, PurePak, PureCell and AireFlow-V filters in these framing systems. AirePleat M11 high capacity “elements” and “rolls” are also offered. These are pleated sections of AirePleat M11 media in selected widths with the metal backing for use in a re-useable metal frame (service pleat). Important
The information provided on this web page is accurate at the time of printing to the best of Airepure Australia’ knowledge, however, it should not be relied upon. Circumstances differ with every installation and location therefore suitability of all Airepure products should be confirmed with a qualified Airepure Technical Representative. ©Airepure Australia 2012